Fig. 3: a) Photograph of a standard meander-shaped layer fabricated by microgel filament deposition printing. The lines have a thickness of 300 µm. b) photograph of a cross-bar pattern obtained by on-top deposition of several microgel filaments. The average linewidth is 1 mm. c) photograph of a donut-shaped microgel construct. The microgels have been fluorescently labelled by FITC-dextran to demonstrate the intrinsic microporosity corresponding to the black non-fluorescent regions, d) light microscopy image of a construct edge showing that fused adhesive microgels form a continuous, three-dimensional selfsupporting scaffold with intrinsic micropores.

Fig. 3: a) Photograph of a standard meander-shaped layer fabricated by microgel filament deposition
printing. The lines have a thickness of 300 µm. b) photograph of a cross-bar pattern obtained by on-top
deposition of several microgel filaments. The average linewidth is 1 mm. c) photograph of a donut-shaped
microgel construct. The microgels have been fluorescently labelled by FITC-dextran to demonstrate the
intrinsic microporosity corresponding to the black non-fluorescent regions, d) light microscopy image of
a construct edge showing that fused adhesive microgels form a continuous, three-dimensional selfsupporting scaffold with intrinsic micropores.